 Lamello Zeta P2 Best Practices
Hi, this is Chris from Lamello and in this video I’m going to show you some basic simple best practices for using your new Zeta. It’s always recommended that we use dust collection with the Zeta — just to keep things cleaner, have a better quality cut, and also so we don’t want dust building…
Read More
How to start using the Lamello Zeta P2
Hey everyone, this is Chris from Lamello USA. Today we’re going to unpack the Zeta machine for you, show you everything that comes in the machine and what it’s used for. So let’s get obviously started. Got your Zeta machine. One of the most important accessories is the stop square. We’ve got a few other…
Read More
How to Join Waterfall Bevel Joints in Thick Material with No Clamps
Hey everyone, it’s Matt from Matt Moore Designs and we’re here in our most recent kitchen renovation where we just finished the installation process of this bar area. The area consists of a beverage cooler, a stack of drawers, but most eye-catching is this solid 8/4 grain wrapped waterfall countertop. Traditional clamping methods to create…
Read More
How To Install Cabinet Face Frames, Filler Strips and Scribes with the Lamello P System
Hey, I’m Keith from Keith Johnson Custom Woodworking, and today we’re on-site doing an installation of a 15-foot built-in. We’ve got painted cabinets below, rift sawn white oak cabinets going above. We have the first run of cabinets in, but we need to scribe our filler strips. Now, this is all pre-finished material, so using…
Read More
How to Build a Waterfall Edge Table
Transcript:This is Chris from Lamello. In this video, we’re gonna show you how to clamp waterfall countertop edges or thick mitered material. We’ve shown you in other videos how you can clamp together a three-quarter material—it’s very easy, it’s a one-step process. Here, we don’t want to make one line of connectors across the middle…
Read More
How to Change the Cutter on Your Lamello Zeta P2
Transcript:Hello, in this video we’re going to show you how to change the cutter on your Lamello Zeta P2 or Zeta P2 cordless. Before you do anything with the Zeta, whether you’re taking the base plate off the machine or performing maintenance, always make sure to unplug the machine. Basic safety 101. Just as a…
Read More
Face Frame Cabinets with P-System
How it works: Lay out connector slot location on the back side of face frames Set the stop square on Zeta P2 to the appropriate height Set the top adjustment knob to the correct setting Cut slots on the face frame Cut corresponding slots on cabinet boxes Install connectors Install pre-load clip Apply glue (when…
Read More
Cutter Differences – Carbide vs. Diamond
Video Transcript: Hey everyone, this is Chris, the U.S. Product Manager for Lamello. I want to give you a brief explanation of the differences between the carbide cutters and diamond cutters, the P-System cutter used with the Zeta P2, and why you might choose one over the other. It’s easy to tell them apart at…
Read More